3E8883 7X2683 2442071 Seal Kits Excavator

One New Cylinder Seal Kit Fits , Fits 215, 215B, 215C, 215D, 219 Models Interchangeable with 7X2683, 7X2683-A
Stevens Lake Parts Rod: 2 3/4", Bore: 4 1/2" || This Is An Aftermarket Replacement Part Made To Meet Or Exceed OEM Specifiions. || Please Note That OEM Part Numbers, Models, & Dimensions Are Intended For Your Cross-Reference. Feel || Some Listings Use Stock Images For Customer Reference, Please Allow For Slight Differences.

Kit King - 3E8880 Aftermarket Hydraulic Cylinder Seal Kit
Kit King USA 5.75 Inch Rod & 8.25 Inch Bore || Equipment Types: Excavators || Compatible Equipment Models: 245 FS, 245, 245B, 245B FS, 245D and More || Typical Hydraulic Appliions: Stick || Fits Cylinder Models: 1011908, 3G2778, 6E5093, 9T1388, 9T9356 and More

2442071 Kit-Seal-H Cylinder Fits 1923008
TCP Warranty

OK - The CID 0324 FMI 06 is present. The action lamp is not causing the diagnostic code. Proceed to test step 2.
NOT OK - The CID 0324 FMI 06 is NO longer present. The lamp or the lamp socket has failed. The correct resistance for a lamp is greater than 10 ohms.Repair: Replace the action lamp.STOPTest Step 2. CHECK THE HARNESS.
Turn the disconnect switch to the OFF position.

Check the connectors that are used in the circuits for any contamination, damage, or other conditions that could cause a short circuit.Examine the wiring harness that contains the suspect circuits that are indiing the low resistance measurement. Look for areas where the wire insulation could be worn or damaged causing contact with the Inverter Cabinet frame or the machine frame.Loe and examine all of the circuit connections that are used in the suspected sections of the temperature sensor circuit. Check each wire section between connectors for a short circuit.Repair the machine harness or replace the machine harness. STOPTest Step 5. CHECK THE STATUS OF THE DIAGNOSTIC CODE

Determine if the CID 0673 FMI 02 is active. Expected Result:The CID 0673 FMI 02 is active.Results:
YES - The CID 0673 FMI 02 is active. The problem has not been corrected.Repair: Check the circuit again. It is unlikely that the ECU has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace