Ptfe 0875407 Seal Kits 350 350 L 5080 Arm Boom Bucket

0875407 KIT SEAL parts 350 350 L 5080 KIT arm boom bucket

087-5407 STICK CYLINDER SEAL KIT APPLICABLE TO EXCAVATOR E330B,330BL AFTERMARKET REPLACEMENT 0875407
MOTTROL PART NO.: 087-5407, 0875407, APPLIION MODEL: E330B,330BL (CYLINDER PART NO.: 7Y-5150, ROD 105 & BORE 150) || QUALITY: WEARABLE, HIGH TEMPREATURE ENDURANCE, HIGH PRESSURE RESISTANCE, GOOD PERFORMANCE || MATERIAL: NITRILE RUBBER(NBR), POLYTETRAFLUOROETHYLENE(PTFE), POLYURETHANE (PU), NYLON, COPPER, STEEL ETC || THE SEAL KIT CONSISTS OF ROD SEAL (IDI/ISI), BUFFER RING (HBY), DUST SEAL (DKB), O-RING, BACK UP RING, PISTON SEAL (SPGO/SPGW/SPG/KDAS), WEAR RING (WR/KZT/N4W)ETC; VARIOUS SEAL KITS AVAILABLE FOR BOOM/ARM/BUCKET HYDRAULIC CYLINDER, MAIN PUMP, CONTROL VALVE, TRACK ADJUSTER, SWING MOTOR, TRAVEL MOTOR, CENTER JOINT, REGULATOR VALVE, PILOT VALVE AND GEAR PUMP, ALSO O-RING BOX, COUPLING, DU BUSHING, PISTON STEEL RING, PUSHER ARE AVAILABLE || NOTE: THE PICTURE IS JUST FOR REFERENCE, THE REAL PRODUCTS MAY LOOK DIFFERENT

Table 1
Tools Needed
Part Number Part Name Quantity
1U-5470
or
198-4240 Engine Pressure Test Group
or
Digital Pressure Indior 1 Refer to Special Instruction, SEHS8907, "Using the 1U-5470 Engine Pressure Group " for the instructions that are needed to use the 1U-5470 Engine Pressure Group. Refer to Operation Manual, NEHS0818, "Using the 198-4240 Digital Pressure Indior " for the instructions that are needed to use the 198-4240 Digital Pressure Indior .The efficiency of an engine can be checked by making a comparison of the pressure in the inlet manifold with the information given in the TMI (Technical Marketing Information). This test is used when there is a decrease of horsepower from the engine, yet there is no real sign of a problem with the engine.

1. You may email us if you have a question or would like to submit a comment.

2. Generally, email will be responded to within 24 hours; except on every Sunday and holidays. We will reply as soon as we back in office.

3. Though we pride ourselves on fast order processing and shipping, sometimes delays may occur. Please be patient, and keep in touch with us via email.

Should you be dissatisfied with our service for any reason, please contact us.

The correct pressure for the inlet manifold is listed in the TMI. Development of this information is performed under the following conditions:
99 kPa (29.7 in Hg) dry barometric pressure
29 °C (85 °F) outside air temperature