|
Product Details:
|
| Sample: | Available | Packing: | Carton Box |
|---|---|---|---|
| Usage: | Engine | Material: | Pu Nbr Ptfe |
| Colour: | Black | Name: | Seal Kit Hydraulic Oil Seal From Seal Supplier |
| Highlight: | PU Hydraulic Pump Seal Kit,2465911 Hydraulic Pump Seal Kit,H Cylinder Hydraulic Pump Seal Kit |
||
2465911 KIT SEAL parts KIT Kit Seal H Cylinder
Replacement for 2465911 Kit-Seal-H Cylinder Fits erpill * FREE SHIPPING *
AECBUY Replacement for 2465911 Kit-Seal-H Cylinder Fits erpill * FREE SHIPPING *
Generator Control (EMCP or PW)
PL HardwareNote: The ® Product Link hardware can sense engine running based on engine speed signal from the datalink or R-terminal wire if connected to an AC or DC source. These hours are only displayed if the other controls are Not present.Last Reported Status
The last reported status of the asset. Under Normal operating conditions, the last reported status will be that of Engine Stopped, Engine in Cool Down, or Engine Running.If conditions are present that may disrupt/prevent the engine from running, a Not Ready to Run status will be displayed. The following conditions are provided to aid in troubleshooting:
Not in Auto Mode: The engine control switch on the EMCP/PW is Not in "AUTO". Generator Control Not in Automatic Warning (4007-31) is present in EMCP/PW event log.
E-stop Pressed: Emergency Stop Shutdown (970-31) is present in EMCP/PW event log.
Q: Can I negotiate the Prices?
A: Sure, we may consider discounts for bulk order of products.
Q: Where has your product sold to?
A: Our products have sold to America, India, Korea, Africa and other countries over the world.
Q: Could you make it from other material?
A: Yes,we can provide you FKM, PTFE, etc.according to your requirements.
Shutdown Occurred: A shutdown fault has occurred. The shutdown fault should be present in the EMCP/PW event log.
Not Ready to Auto-Parallel: Generator Not Ready to Auto Parallel Warning (3568-31) is present in EMCP 4.4 event log.Engine Fault Codes
Engine controls support various fault codes. The specific codes can vary per engine type. The datalink these codes are communied on can also vary. Engine fault codes can be communied on ’s proprietary datalink (CDL) or J1939 Controller Area Network (CAN). Identify the datalink supported by reviewing documentation for your genset package.EMCP/PW Fault Codes
EMCP/PW supports various fault codes. The specific code supported depends the EMCP/PW hardware and software installed. Always ensure that you have the latest EMCP/PW software installed. EMCP II/II+ family of controls communies
Contact Person: SUNNY
Tel: 86 18605253464
