9J5108 7X2729 7X2761 7X2671 7X2660 7X2767 7X2710 7X2698 7X2699 7X2697 7X2740 7X2752 7X2791 8T1373KIT-SEAL

9J5108 Hydraulic Motor Seal Kit 7X2729 7X2761 7X2671

9J5108 7X2729 7X2761 7X2671 7X2660 7X2767 7X2710 7X2698 7X2699 7X2697 7X2740 7X2752 7X2791 8T1373KIT-SEAL

7X2710 KIT-SEAL parts 966D, 966F II, 970F, 992C, 992D KIT

Alternative (cross code) number:
CA7X2710
7X-2710
7X2710

Kit King - 7X2698 Aftermarket Hydraulic Cylinder Seal Kit
Kit King USA 3 Inch Rod & 6 Inch Bore || Equipment Types: Crawler Loaders, Integrated Tool Carriers, Scrapers, Wheel Loaders || Compatible Equipment Models: 623, 623B, 623E, 623F, 623SC, 950, 950B, 950E, 950F, 950G, 960F, 960G, 962G, 963, IT62G and More || Typical Hydraulic Appliions: Floor, Lift || Fits Cylinder Models: 1188296, 1250024, 1U1147, 1U1148, 8J1821, 9T1403 and More

Compatible equipment models: 7X2710:

WHEEL LOADER 966D 966F II 970F 992C 992D

 

Information:
Illustration 1 g00328807
Right side engine viewThickness of a new cylinder head ... 100.03 0.76 mm (3.938 .030 inch)Apply 6V-4876 Lubricant on the threads of all of the bolts except bolt (25). Tighten all of the bolts in the following sequence: Tighten all of the bolts in the number sequence to the following torque. ... 150 15 N m (115 12 lb ft) Tighten all of the bolts in the number sequence to the following torque again. ... 250 17 N m (185 13 lb ft) Tighten all of the bolts in the letter sequence by hand to the following torque. ... 43 7 N m (32 5 lb ft)

 

Remove Balancer Shaft Bearings (3304)
start by:a) remove flywheel housingb) remove oil pan platec) remove oil pumpd) remove balancer shafts1. Remove the front bearing for the balancer shaft with tooling (A).

2. Remove the center bearing for the balancer shaft with tooling (A).3. Remove the rear bearing for the balancer shaft with tooling (A).4. Do Steps 1, 2 and

3 again for the other balancer shaft bearings.Install Balancer Shaft Bearings (3304)
1. Install balancer shaft front bearing (1) with tooling (A). Make sure the oil hole in the bearing is in alignment with the oil hole in the cylinder block. The bearing must be .03 .02 in. (0.8 0.5 mm) inside the end of the cylinder block after installation.2. Install the balancer shaft center bearing with tooling (A).

4.Make sure the oil hole in the bearing is in alignment with the oil hole in the cylinder block.3. Install balancer shaft rear bearing (2) with tooling (A). Make sure the oil hole in the bearing is in alignment with the oil hole in the cylinder block.

5.The bearing must be .03 .02 in. (0.8 0.5 mm) inside the end of the cylinder block after installation.end by:a) install balancer shaftsb) install oil pumpc) install oil pan plated) install flywheel housing