PC300 7 PC360 7 KOMATSU Excavator O Ring Hydraulic Main Pump Seal Kit

PC300 7 PC360 7 KOMATSU Excavator O Ring Hydraulic Main Pump Seal Kit

PC300-7 360-7 CONTROL VALVE Hydraulic main Pump Seal Kit arm boom bucket use for KOMATSU Excavator

SEAL KITS---
BOOM CYL SEAL KIT . ARM CYL SEAL KIT . BUCKET CYL SEAL KIT
MAIN PUMP SEAL KIT . HYDRAULIC PUMP SEAL KIT . PIOLVE VALVE SEAL KIT.
GEAR PUMP SEAL KIT VALVE SEAL KIT .PUMP PLUNGE SEAL KIT .
.CONTROL VALVE SEAL KIT. SWING MOTOR SEAL KIT .. TRAVEL MOTOR SEAL KIT .
ADJ CYL SEAL KIT. CENTER JIONT KIT BREAKER SEAL KIT

Oil Seal -- TC TB TCV TCN DB DC DCY TC4Y ISPID BABSL

Piston seal : SPGW SPGO SPG SPGA NCF ODI OSI OUIS OHM OKH DAS , OK SELA OUY D-8

Rod Seal : IDI IUH ISI IUIS D-2 D-3 D-6
　
U Seal : UPI UPH USH USI V99F V96H UN

Buff Seal : HBTS HBY HBTTS D-14

Wiper Seal : DKB DKBI DKBI3 DKBZ DKI , DWI DKH DWIR DSI LBI LBH VAY DH ME-2 ME-8

Wearing Ring : WR KZT RYT

　
Rotary Seal : ROI D-14 SPN

Back Up Ring : N4W BRT-PTFE BRT-NYLON BRT2 BRT3 BRT-G BRT-P BRN2 BRN3

O Ring : Oring Kit P series G series AS series S series M 1.5 series M 2.0 series M 1.9series M 2.4 series

M 3.0 series M4.0 series

Piston seal : SPGW SPGO SPG SPGA NCF ODI OSI OUIS OHM OKH DAS , OK SELA OUY D-8

Rod Seal : IDI IUH ISI IUIS D-2 D-3 D-6

Valve Pusher Floating oil seal Bushing hydraulic cylinder seals cylinder seal kits

Freezing
Wet climate during shipment
Wet climate during storageNote: These tests should be conducted prior to any power connections or control connections that are being made.Enclosures
Note: Generator sets that are shipped in an enclosure will require alterations if the enclosure is removed and the generator set is placed in operation. Also, open generator sets that are shipped without an enclosure will require alterations if an enclosure is installed and the generator set is placed in operation. These alterations may include the following items: different grills for the generator, different air cleaners and different covers for the electrical box. Please contact your dealer in order to obtain the proper parts for alterations.The following illustrations represent the C2.2 Genset. There are mainly two differences between the enclosures for the two gensets that are covered in this manual. The enclosure for the C1.5 genset has only one top panel, and the side panels for the C1.5 are single panels.Use the following steps in order to open the side panels:
Illustration 1 g00955646
Use latch (1) to release the top of the panel.
Illustration 2 g00955648
Tilt panel (2) outward for approximately 20 degrees (A). Damage may occur to pins (3), panel (2) or the frame